If you have a System or Conventional boiler and you have been looking for a hot water cylinder installer, then you have come to the right place. At Senior Plumbing and Heating, we have been installing hot water cylinders in Bournemouth and Poole for over 15 years. We have extensive experience installing vented and unvented hot water cylinders.
Give us a call for a free no-obligation quote.
Vented Hot water cylinders work alongside a cold water storage tank typically situated in the roof. Water from the mains goes into the cold water tank then fed into the hot water cylinder to be heated and distributed to your taps. Vented cylinders have a vent pipe rising from the cylinder itself and into the cold water tank. The purpose of the vent pipe is to release excess pressure and heat in the event of a fault.
On the other end, Unvented Hot water cylinders are fed cold water directly from the mains which is heated and distributed to your taps. Since the tanks are sealed, they either have a bubble top unit or are integrated with an expansion vessel to hold the pressurized water inside the tank.
Our process begins with a call to arrange a visit to your property. This helps our heating engineers run a proper assessment and even help you identify the best hot water cylinder for your property and boiler. Once we have sourced the cylinder, the installation process begins and it will depend on the project. If you are looking for a replacement, then the process is more straightforward. If the project involves replacing instead of installing a combi boiler with a system or regular boiler, then this might be more complex but either way we will work efficiently on the boiler and the hot water cylinder.
Legally, only a Gas Safe Registered Heating Engineer can install, service or repair a hot water cylinder.
The size of your tank ultimately depends on the size of your house or property. The number of bathrooms is a big factor to consider.
Most cylinders have an original sticker that indicates the capacity, height and diameter of your cylinder.
Complete detachment of the old pump and fitting of the new pump can begin. The new pump can be Grundfos UPS3 Domestic pump or a UP15 – 10BUC5 Bronze Circulator Pump. These pumps are good for radiant heating and solar.
Unless something comes up, at the very most a conversion takes 5 hours to complete.
Your heating engineer can offer to carry it and dispose of it safely.
Whether it’s heating, Gas or Boilers we’re here to help!
A poorly installed hot water cylinder can get damaged easily and repairs can be costly. For unvented hot water cylinders, incorrect installation can be extremely dangerous. we ensure that we have all the correct qualifications, have the requisite experience and are Gas Safe Registered. Not only do we install hot water cylinders, but we also conduct repairs as well. We also service your cylinder because it needs an annual service just like your boiler.
RESPECT FOR YOUR HOME
We treat your property with the utmost care ensuring no mess or dirt is left behind.
Our aftercare is as important and as professional as our installation.
POST INSTALL WALK THROUGH
Before leaving we will ensure you know how your new system works, handing over full documentation and manufacturer’s instructions.
24 HOUR EMERGENCY SERVICE
No callout charge! Fast, reliable emergency callout service. We aim to be with you within the hour.